........Making Your Tire Sandals First, place either foot in the center of a large piece of paper, at least an 8 1/2 x 14. Trace around your foot, being careful at all times to keep the pencil straight up and down. Next make a mark on each side, directly down from the point on your ankles (A) (see pattern at the end of this web page). Also make a mark at the point along the inside of your foot, directly back from your big toe (B). Remove your foot from the pattern. Now sketch a bigger outline around the tracing of your foot. Add about 3/8 inch for the toes and sides, but not to the back. Then use a ruler and bisect the pattern lengthwise, extending the line three inches past the heel. This serves as a guide to help you sketch the rear tab accurately. Now connect the marks you made by your ankles (A), extending a line three inches beyond each side of the pattern. These tabs will be sketched in front of this line. Also draw a line for the front tabs, extending from the single mark (B) across the pattern, perpendicular to the line that bisects the foot lengthwise. To learn more and the rest of the instructions, go to.. http://www.hollowtop.com/sandals.htm tenzicut